Concrete cutting in Kingston NY - clean cuts, planned before the saw starts

One national cost guide says saw cutting a concrete slab usually costs about $4 to $15 per linear foot across the US. That's the sawing alone. Wall cuts run higher per foot, a small job can be set by a minimum charge, and breaking and hauling the pieces can cost more than the sawing, so your written estimate lists each part.

If the wall carries weight, yes, and we want an engineer's say before we cut. One field guide explains why, since an opening changes how the wall carries its load, and it leaves the size, the spot and any new lintel, the beam across the top, to the engineer.

So the saw doesn't hit what's buried inside, like rebar, the steel bars that strengthen concrete, tensioned cables or live wiring. One field guide's rule is "no scan, no cut," and it says to find all three with scanning locators first, so we put the scan on the calendar ahead of the cutting day.

It trades dust for slurry, a gray watery paste that gets vacuumed or contained as the cut goes. Most flat, wall and wire sawing runs wet to keep dust down, while smaller hand saws often cut dry with a vacuum, so we'll tell you which we're using and how we'll clean up before we start.

Indoors it calls for a hydraulic or air-powered saw, not a gas one. A cost guide reports a basement incident documented by OSHA in which workers using a gasoline-powered wet saw died of carbon monoxide poisoning, and OSHA's example recommends hydraulic or pneumatic saws in enclosed spaces like that.

In the City of Kingston, the Building Safety & Zoning Enforcement office handles all building inspection and permitting, working out of the rear of the Rondout Fire Station at 5 Garraghan Drive. Some Kingston addresses fall under the Town of Kingston instead, and when your job needs a permit, we take care of the application with you.

Yes, New York state law requires a contractor to give you a written contract for home improvement work. The Attorney General says it should include a timeline, a payment schedule and the project's specifics, so check that yours spells out the cut, the cleanup and the hauling.

Clear access to the spot, plus water and power close by. One core drilling trade specification makes the owner responsible for providing water and power to the coring crew, so it's worth sorting out where they'll come from before the cutting day.